BMW HP2 Sport Rider's Manual page 79

Bottom fork brace with
slider tube
Tightening sequence: 2x
each side, alternately
18 lb/ft (25 Nm)
If necessary, tighten quick-
release axle 5 with specified
torque.
Quick-release axle in axle
mount
37 lb/ft (50 Nm)
If necessary, tighten axle
clamping screw 4 with
specified torque.
Clamping screw for
quick-release axle
14 lb/ft (19 Nm)
Lower motorcycle and remove
lifting tool.
Lay engine spoiler with hold-
ers 3 on mounts 4 on left and
right from behind and support
at front.
Install screw 2 on left and right
hand-tight.
Install screw 1 on left and right
hand-tight.
Adjusting suspension
strut length
Make sure ground is level and
firm and park motorcycle.
Removing rear wheel (
5
77
z
131)