Table of Contents
Advertisement
13.
Locate the front foot assembly along with the
corresponding hardware that secures it to the Spinner
frame (Fig. 13).
Hardware:
M8x1.25x30mm Hex Head Bolt
8mm Split Lock Washer
8mm Plain Washer
Threaded Two Hole Bar
14.
Insert the threaded bar (Fig. 14) into each slot at the
bottom section of the front foot bracket.
15.
Install the front foot assembly (Fig. 15) and tighten the
hardware using the supplied multi-sized open wrench.
Note: These bolts must be torque between
35-40 Lb-Ft (47-54 Nm).
18
| SPINNER BLADE BELT BIKE MANUFACTURED by STAR TRAC - OWNER'S MANUAL
Qty:
2
2
2
1
Fig. 13
Fig. 14
Fig. 15
Advertisement
Table of Contents
