Star Trac SPINNER 7240 Series Installation & Owner's Manual page 17

10.
Install the rear foot assembly (Fig. 10) and tighten
hardware using the supplied multi-sized open wrench.
Note: These bolts must be torqued between 35-40
Lb-Ft (47-54 Nm).
11.
Stand the Spinner frame on the opposite end and place
a piece of foam or cardboard under the seat post frame
section (Fig. 11).
12.
Split and remove (Fig. 12) the foam covering the front
of the Spinner frame.
SPINNER BLADE BELT BIKE MANUFACTURED by STAR TRAC - OWNER'S MANUAL |
Fig. 10
Fig. 11
Fig. 12
17