Maintenance; Moving And Leveling; Preventive Maintenance; Daily Maintenance - Star Trac SPINNER 7240 Series Installation & Owner's Manual

Star trac spinner 7240 series blade belt bike

Table of Contents

aintenance

This section provides the procedures to maintain the Spinner

Moving & Leveling

To move the bike to a new location:

Lift the bike from the rear and use the front wheels (located on the front leg, below the handlebar) to roll the bike from one location to

another.

To level the bike:

Use the four leveling adjusters (located on the underside of the front and rear legs) to compensate for uneven floor surfaces.

Perform regular scheduled preventive maintenance procedures to maintain your Spinner

condition.

The life of your Spinning product will be determined by how consistently you perform the daily maintenance procedures. Dry the

Spinning bike after each use to remove sweat and moisture. It is best to use a liquid non-abrasive cleaner diluted with water.

Wipe Down / Cleaning

To prevent the build-up of rust and other forms of corrosion, wipe down the bike at the end of each day (or preferably at the end of

each class). Raise all posts to the highest setting to expose moisture. Using an absorbent cloth, focus on all areas that perspiration

can settle. Give particular attention to the following areas:

• Handlebar

• Seat / adjustable slide for the seat

• Flywheel

• Back leg assembly

• Belt guard

• Brake knob and bolt assembly

• Pop-pins

• Leveling feet

NOTE: Never use abrasive cleaning liquids or petroleum-based solvents when wiping down the bike.

NOTE: Release all tension from the resistance knob after each use to allow for perspiration to evaporate. If bikes are used in a class

setting, the instructor may direct class participants to release all tension for the resistance knob after each use.

SPINNER BLADE BELT BIKE MANUFACTURED by STAR TRAC - OWNER'S MANUAL |

indoor cycling bikes in serviceable condition.

indoor cycling bike in serviceable

Table of Contents