Configuration Restore & Backup; Configuration Restore From Http; Configuration Restore From Tftp - D-Link DGS-1100-16 Reference Manual

Configuration Restore & Backup

Configuration Restore from HTTP

This window is used to initiate a configuration restore from a local PC using HTTP.
Note: If the switch is in HTTPS mode, the firmware or configuration cannot be upgraded using
regular HTTP.
To view the following window, click Tools > Configuration Restore & Backup > Configuration
Restore from HTTP, as shown below:
The fields that can be configured are described below:
Parameter
Source File
Click the Restore button to initiate the configuration restore.
Click Effective immediately (running-config) to have the uploaded configuration loaded
immediately.
Click Take effect after the next boot (startup-config) to load the configuration after the switch has
been rebooted.

Configuration Restore from TFTP

This window is used to initiate a configuration restore from a TFTP server.
To view the following window, click Tools > Configuration Restore & Backup > Configuration
Restore from TFTP, as shown below:
The fields that can be configured are described below:
Parameter
TFTP Server IP
Source File
Figure 13-7 Configuration Restore from HTTP window
Description
Enter the source filename and path of the configuration file
located on the local PC. Alternatively click the Browse button
to navigate to the location of the configuration file located on
the local PC.
Figure 13-8 Configuration Restore from TFTP window
Description
Enter the TFTP server's IPv4 address here.
Enter the source filename and path of the configuration file
located on the TFTP server here.
D-Link DGS-1100 Series Switch User Manual
7 7 5 5