Mask
Gateway
DHCP retry Time
Click the Apply button to accept the changes made.
IPv6 Interface
This window is used to configure the IPv6 settings of the switch.
To view the following window, click System > System Information Settings > IPv6 Interface, as
shown below:
The fields that can be configured are described below:
Parameter
IPv6 State
Static IPv6 Address
Click the Apply button to accept the changes made.
Port Configuration
Port Settings
This window is used to view and configure the Switch's port settings.
To view the following window, click System > Port Configuration > Port Settings, as shown below:
If Static is selected, enter the IP address of the switch. If
DHCP or BOOTP is selected, the automatically obtained
network mask will be displayed.
If Static is selected, enter the IP address of the switch. If
DHCP or BOOTP is selected, the automatically obtained
gateway will be displayed.
If DHCP is selected, enter the number of times to retry
obtaining an IP address.
Figure 5-4 Peripheral Settings window
Description
Select whether to Enable or Disable IPv6 functionality.
If enabled, enter the static IPv6 address of the switch.
Figure 5-5 Port Settings window
2
2
0
0
D-Link DGS-1100 Series Switch User Manual