Panasonic KX-UTG200 Setup Manual page 308

5.6.8 Tone Settings
Value Range
Default Value
HOLD_TONE_RPT
Value Format
Description
Value Range
Default Value
HOLD_TONE_TIMING
Value Format
Description
Value Range
Default Value
HOLD_ALARM_FRQ
Value Format
Description
Value Range
Default Value
HOLD_ALARM_GAIN
Value Format
Description
Value Range
Default Value
308 Administrator Guide
(-80)–0
0
Boolean
Specifies whether the hold tone is repeated.
•
Y/Yes (Repeat)
•
N/No (No Repeat)
Y
Comma-separated Integer
Specifies the pattern, in milliseconds, of the hold tone using up to 10
whole numbers (off 1, on 1, off 2, on 2...) separated by commas.
Note
•
It is recommended that you set a value of 500 milliseconds or
more for the first value (off 1).
0–16000 (0: Infinite time)
Note
•
Avoid setting 1–50 for any of the values.
500,190,190,190,2890
Comma-separated Integer
Specifies the dual-tone frequencies, in hertz, of the hold alarm using 2
whole numbers separated by a comma.
0, 200–2000 (0: No tone)
425
Integer
Specifies the gain, in decibels, of the hold alarm.
(-80)–0
0
Document Version 2015-01