Panasonic KX-UTG200 Setup Manual page 102

4.3.4 Ethernet Port Settings
IPv6 DNS1
Description
Value Range
Default Value
Configuration File Reference
IPv6 DNS2
Description
Value Range
Default Value
Configuration File Reference
4.3.4 Ethernet Port Settings
This screen allows you to change the connection mode of the Ethernet ports and the VLAN settings.
Note
•
When you change the settings on this screen and click [Save], after the message "Save Complete!"
has been displayed, the unit will restart automatically with the new settings applied. If a unit is on a call
when "Save Complete!" has been displayed, the unit will restart after the unit returns to idle.
•
Incorrect settings may cause a network failure. In such a case, you cannot access the Web user
interface anymore. To access it again, you need to correct the speed/duplex settings or perform IP
Reset through phone user interface programming. For details, refer to the Operating Instructions on
the Panasonic Web site (® see Introduction).
102 Administrator Guide
Specifies the IPv6 address of the primary DNS server.
Max. 46 characters
Not stored.
IPV6_STATIC_DNS1_SERVER (Page 273)
Specifies the IPv6 address of the secondary DNS server.
Max. 46 characters
Not stored.
IPV6_STATIC_DNS2_SERVER (Page 273)
Document Version 2015-01