Panasonic KX-UTG200 Setup Manual page 254

5.4.5 Firmware Update Settings
Value Range
Default Value
Web User Interface Reference
FIRM_UPGRADE_AUTO
Value Format
Description
Value Range
Default Value
FIRM_UPGRADE_SUPPORT_IMAGE_MODE
Value Format
Description
254 Administrator Guide
Max. 1024 characters
Note
•
The format must be RFC 1738 compliant, as follows:
"<scheme>://<user>:<password>@<host>:<port>/<url-path>".
–
"<user>" must be less than 127 characters.
–
"<password>" must be less than 127 characters.
–
"<user>:<password>@" may be empty.
–
":<port>" can be omitted if you do not need to specify the
port number.
•
If "{mac}" is included in this URL, it will be replaced with the
unit's MAC address in lower-case.
•
If "{MAC}" is included in this URL, it will be replaced with the
unit's MAC address in upper-case.
•
If "{MODEL}" is included in this URL, it will be replaced with the
unit's model name.
•
If "{fwver}" is included in this URL, it will be replaced with
"FIRM_VERSION" depending on the system. Note that this rule
differs from other parameters such as "SIP_USER_AGENT".
Empty string
Firmware File URL (Page 184)
Boolean
Specifies whether to display a confirmation message asking the user
to perform a firmware update (manual) or perform the firmware update
without asking the user (automatic) when the unit detects a change in
the firmware version.
Note
•
This setting is available only when
"FIRM_UPGRADE_ENABLE" is set to "Y".
•
Changing this setting may require restarting the unit.
•
Y/Yes (Enable automatic firmware update)
•
N/No (Disable automatic firmware update)
Y
Integer
This flag determines whether either normal or single image files, or both
image files are supported by firmware upgrade.
Document Version 2015-01