Table of Contents
Advertisement
Installing the Memory Board
To install the 2 MB memory board in the MultiPASS L90, follow these steps:
1. Unplug the MultiPASS L90.
2. Remove the document support for scanned documents from the unit.
3. Use the front cover release latch to open the front cover.
C-6
Options
Make sure the MEMORY lamp is off. If it is on, refer to page 6-15 for
instructions on printing the documents in memory.
Remove any documents or printed pages from the unit before installing the
memory board.
If documents remain stored in memory when the memory board is installed,
the unit will print out the Memory Clear report when the unit is next plugged
in.
Appendix C
Advertisement
Table of Contents
