Table of Contents
Advertisement
Using the MultiPASS L90 with an Answering Machine
1. Press the ANS HOOK UP/MANUAL button until the ANS HOOK UP
2. Set your answering machine to answer.
3. When not in use, turn the answering machine off and switch the mode to
Adjusting the MultiPASS L90 for Different Types of
Answering Machines
Some answering machines listen for a pause and disconnect the line after a
certain period of silence. When used with an answering machine, your unit also
listens for a pause to determine if a fax is being received.
If your answering machine disconnects before the unit has a chance to switch to
receive mode, the caller may not be able to send a fax on the same call.
If you experience this problem, adjust the ANS/FAX SW TIME setting in the
RECEIVE (RX) SETUP, (Qp. A-9). Adjust so that the required time for the
unit to switch occurs prior to the time when your answering machine disconnects
automatically.
Chapter 5
lamp goes on.
ANS HOOK UP
MANUAL
The unit allows the answering machine to answer, then listens for a fax
tone, and switches to receive mode automatically if it detects the tone.
The unit also listens for 6 seconds of silence, also an indication that a fax is
coming in. After 6 seconds of silence, the unit automatically switches to
receive mode.
Manual receive (MANUAL lamp on) or Automatic receive (both the ANS
HOOK UP and MANUAL lamps off) using the ANS HOOK UP/MANUAL
button.
Receiving Faxes
5-11
Advertisement
Table of Contents
