Display Interface : Vga - Contec IPC-BX800-DC400 User Manual

Display Interface : VGA

Connector for display connection is provided. Connector name is VGA(HD-SUB 15P).
When used together with an LVDS interface, it enables dual screen display.
Table 5.9. Display Connector
Connector type
5
10
15
Pin No. Signal name
1 RED
2 GREEN
3 BLUE
4 N.C.
5 GND
6 GND
7 GND
8 GND
For the LCDs that can be connected, please refer to "Chapter7 List of Options".
Display driver
Install the appropriate audio driver for your OS from the bundled CD-ROM [IPC-SLIB-01].
(For information on the latest version of IPC-SLIB-01, check the CONTEC's web site.)
CAUTION
When the analog display is used, Windows MS-DOS may not be properly displayed in full-screen
mode.
This is because the frequency and resolution of Windows and MS-DOS (full-screen display) are the
same due to the screen settings while the display parameters are different.
For display, as only one parameter can be stored for one frequency or resolution, only either of
Windows or MS-DOS screen can be displayed properly.
In this case, change the resolution or display frequency of Windows so that it is not the same as for
the MS-DOS display.
If the analog display isn't connected on startup, image signal may not be output. In this case, the
image signal will be output by pressing Ctrl+Alt+F1 keys on the keyboard.
IPC-BX800 Series User's Manual
HD-SUB 15 pin (FEMALE)
1
6
No.4-40UNC
Inch thread
11
Signal name
Pin No.
+5V
9
GND
10
N.C.
11
DDCDATA
12
HSYNC
13
VSYNC
14
DDCCLK
15
5. Each Component Function
49