Removing/Attaching the Recovery IDE Connector Cover
(1) When using the optional CD-ROM/DVD-ROM drive (IPC-CDD-03) and IDE cable (IPC-CDC-04),
remove the recovery IDE connector cover before connecting them.
(2) After use, remove the CD-ROM/DVD-ROM drive and IDE cable and put back the recovery IDE
connector cover. Do not tighten screws with excess force. The tightening torque should be 4kg/cm
or less.
Figure 3.3. Attaching the Recovery IDE Connector Cover
CAUTION
Screw holes may be damaged if screws are tightened with a torque greater than the specified torque.
Attaching the FG
(1) Use screws to attach the FG
Figure 3.4. Attaching the FG
CAUTION
The FG pin of this product is connected to the GND signal of the DC power connector (DC-IN).
Note that the connection cannot be cut off.
IPC-BX800 Series User's Manual
3. Hardware Setup
13