Hardware Setup; Attaching The Cf Card Retaining Bracket; Attaching The Fitting Used To Attach To The Main Unit - Contec IPC-BX800-DC400 User Manual

3. Hardware Setup

Hardware Setup
- Before you start, be sure that the power is turned off.
- Remove only those screws that are explained. Do not move any other screw.

Attaching the CF Card Retaining Bracket

(1) After inserting a CF Card, fasten the bundled CF Card retaining bracket with a screw.
Figure 3.1. Attaching the CF Card Retaining Bracket
CAUTION
Insert the CF Card face up.

Attaching the Fitting Used to Attach to the Main Unit

(1) Use screws to attach the bundled fitting to the main unit
Do not tighten screws with excess force. The tightening torque should be 4kg/cm or less.
Figure 3.2. Attaching the Fitting Used to Attach to the Main Unit
CAUTION
Screw holes may be damaged if screws are tightened with a torque greater than the specified torque.
12
IPC-BX800 Series User's Manual