Hitachi RCI-1.0FSN3 Service Manual page 39

2 Unit installation
Once the air panel is installed, the final height of the indoor unit
can be adjusted using a wrench through the corner cover.
Excessively adjusting the height leads to condensation leaks from
the drain pan.
C A U T I O N
Do not move the air louver by hand. The drive mechanism
may be damaged.
Removal of the corner cover after the air panel installation
Insert a coin or a flat-tipped screwdriver into the groove -1- and
turn it gently downwards. Perform the same operation in grooves
-2- and -3-.
Lift the receiver and, once the securing tabs (3 positions) have
been removed, remove it.
Electrical connection of the air panel
C A U T I O N
Switch off the power supply to the unit before coupling the connectors, otherwise the automatic louver will not
work.
The following connector is used with the air panel (see from the lower
surface of the air panel without the air inlet grille).
27
SMGB0077 rev.0 - 01/2013
Coin or slotted screwdriver
Corner position dent part
Couple the connectors as indicated in the figure (view
of the electrical box from above).
2