Hitachi RCI-1.0FSN3 Service Manual page 239

6 Optional functions
Element Optional function
Only PC-ARF: Fall distance of
d7
elevating panel
KPI: ventilation mode
E1
KPI: Increasing air supply
E2
volume
Not available
E3
Pre-cooling / pre-heating
E4
period
Not available
E5
Indoor fan operation time after
E6
cooling operation stoppage
Not available
E7
Fan operation control at
E8
heating Thermo - OFF
Not available
E9
227
SMGB0077 rev.0 - 01/2013
Individual
Settings Condition setting
setting
00
01
02
03
O
04
05
06
07
00 Automatic ventilation
Ventilation with total
01
heat exchanger
O
Ventilation with
02 bypass (no total heat
Not activated
00
01 Activated function
O
Not activated
00
01 Activated function
00
Not available
O
Use at 00 conditions
01
KPI:
00
O
01
02
00
Not available
O
Use at 00 conditions
01
Not activated
00
O
01
02
00
Not available
O
Use at 00 conditions
01
Not activated
00
O
01 Activated function
00
Not available
O
Use at 00 conditions
01
Description
200 cm (Standard)
100 cm –
150 cm –
200 cm –
250 cm –
300 cm –
350 cm –
400 cm –
This function is used to set the unit
ventilation mode with energy / heat
recovery.
exchange)
function This function is used to increase the
air supply pressure in the room.
function This function selects the enthalpy
sensor input.
–
Standard
This function delays the unit start-up
with energy / heat recovery
30 minutes
60 minutes
–
This function prevents the
function
condensation accumulation in the unit
60 minutes by keeping the fan running after it is
switched off.
120 minutes
–
function This function reduces the unit fan
speed to prevent cold draughts.
–
6