Installing Countertop Dispenser With Legs Accessory - Follett C125A Installation, Operation And Service Manual

Fig. 2 Bottom exiting utilities
(countertop units)
3/4" FPT drain
3/8" FPT
water inlet
Installing countertop dispensers with legs accessory
Do NOT tilt unit further than 30° off vertical.
!
Countertop dispensers that sit on legs (not bolted to
counter) can be inadvertently moved. Care should be
taken when operating and cleaning to avoid accidents.
1. Carefully tip dispenser back to expose underside and block up
in place.
2. Screw legs (shipped taped to drain pan of dispenser) into
dispenser bottom, taking care to seat legs securely against
underside of dispenser.
3. Position unit in desired location and adjust bullets on legs to
level in both directions.
4. Attach bottom panel and hardware to bottom of dispenser with
supplied screws (Fig. 4).
5. Make final connections.
(b-1) Move pipe plug
to back of unit
(c) Remove poly tubing and
fitting for water inlet
Fig. 3
(b-2)
1.5"
(39mm)
.9"(23mm)
7
Rear exiting utilities
(countertop units)
16"
(407mm)
11.7"
(298mm)
8.1"
(206mm)
3/4" FPT drain
power cord
Fig. 4 Bottom panel assembly
COUNTER TOP DISPENSER WITH LEGS
3/8" FPT water inlet
bottom
panel
screw
leg