Installing Wall Mount Dispensers - Follett C125A Installation, Operation And Service Manual

Fig. 5 Wall mount bracket and fastener requirements
wall mounting
bracket
support
bracket
WALL PREPARATION: Wall and fasteners
must be of sufficient strength to carry weight
!
of unit (185 lbs/83.9kg). Hardware for this is
not included.
Fig. 6
Wall mount mounting dimensions
6.5"
(166mm)
16"
(407mm)
screw
13"
(331mm)
8"
(204mm)
1.4" (36mm)
10"
(254mm)

Installing wall mount dispensers

!
1.
2.
3.
4.
!
5. Install two (2) supplied 3/8"-16NC screws
through bottom of support bracket into bottom of
dispenser (Fig. 5).
6. Make final connections.
7. Attach bottom panel and hardware to bottom of
dispenser as shown in Fig. 8.
Fig. 7
outline of
dispenser
.437
14"
(356mm)
7"
(178mm)
3"
(77mm)
3"
bottom of
(77mm)
dispenser
8
Wall mount models require 30" (762mm)
deep counters and front of sinks must be
installed no more than 2" (51mm) from front
of counter.
Supporting wall must be reinforced to
handle dispenser weight (185 lbs/83.9kg).
Cut utility hole in wall as shown in Fig. 10.
Mount support bracket to reinforced wall using
fasteners of sufficient strength (fasteners not
included, Fig. 6).
Rough in water and drain lines (Fig. 10).
Lift dispenser onto support bracket, positioning
unit such that hook on back of dispenser is
captured by support bracket angle (Fig. 7).
Caution: Do NOT rest dispenser weight
on bottom of support bracket.
Wall mount side view
22.5"
(572mm)
18"
(458mm)
32.5"
(826mm)