Disassembly And Replacement Instructions - Follett C125A Installation, Operation And Service Manual

Disassembly and replacement instructions

Dispense chute removal
1. Remove top cover.
2. Remove stainless front cover.
3. Slide plastic dispense chute cover up and out to
remove.
4. Remove four (4) push fasteners holding dispense tube
in place and remove tube.
Dispense wheel and drive bar removal
1. Remove all ice from storage area of dispenser.
2. Remove center thumbscrew, locking plate, two
wingnuts and backing plate from front of storage
hopper (see drawing at right).
3. Remove stud assembly, agitator, spacer, baffle, wheel
and drive bar in this sequence.
Wheelmotor removal
1. Remove dispense wheel and drive bar (see above).
2. Remove four (4) hopper/support plate mounting screws
and washers (see drawing below).
3. Move hopper assembly 1/2" to left.
4. Remove four (4) dispenser motor bracket mounting
screws and washers.
5. Loosen only two (2) lower screws on drive coupling
and remove from motor shaft.
6. Remove four (4) screws holding motor to mounting
bracket.
MOVE HOPPER ASSEMBLY 1/2"
TO LEFT
drive coupling
assembly
shield
mounting
bracket
dispense motor
dispense motor mounting
screws & washers
stud assembly
agitator
spacer
baffle
dispense wheel
drive bar
locking
plate
thumbscrew
mounting
screw &
washer
hopper/
support
plate
assembly
28
wingnut
backing plate