Installation; Countertop Installation - Follett chewblet 7CI100A Installation, Operation And Service Manual

Installation ––––––––––––––––––––––––––––––––––––––––––––––––––––––––
CAUTION!
No service or maintenance should be performed until the technician
has thoroughly read this service manual. Except for routine cleaning
and sanitizing, only qualified technicians should attempt to service
or maintain this equipment.

Countertop Installation

The 7 Series countertop model is designed to fit on counters underneath
standard mounted cabinets, this does not apply to 15 Series models . See
page 4
for dimensions . Installation instructions for freestanding model
may be found on page
1 . A clearance of at least 3" (77 mm) is required behind and on
each side of the dispenser for electrical connection and ventilation
(Fig . 1) .
2 . Rough-in the electrical service and water line .
§ Electrical: 115V, single phase, 15A receptacle required . The dispenser
has an integral 8 ft . (2 .4 m) cord and plug .
§ Water: supply line (with shut-off valve) connects to the dispenser's 1/4"
MPT inlet .
NOTICE!
If installing optional Drip Tray Drain Kit or Leg Accessory,
complete those steps before proceeding. Refer to instructions
included with the Drip Tray Drain Kit, or see
Accessory instructions.
3 . Connect water line . Recommended routing (Fig . 2) allows easy access
to water for cleaning and sanitizing procedure .
4 . If installing the optional internal water filter*, please see
Maintenance/Cleaning Mode on page 12
not, proceed to step 5 .
* If your dispenser has the internal water filter option, the water filter must be
installed for the dispenser to operate . Because internal components will need to
be accessed for both procedures, Follett recommends installing the water filter
just prior to initial sanitizing .
5 . Connect power supply .
6 . Sanitize the dispenser prior to use (see the Initial Sanitizing Kit
instructions shipped with this unit) .
8 Dispenser and Icemaker 7CI100A/7FS100A, 15CI100A/15FS100A
9 .
before proceeding . If
page 9 for Leg
Fig . 1
countertop models
minimum 3" (77 mm)
clearance required
Fig . 2
3' (91.4 cm)
Plug
Valve
1/4" MPT