Follett C125A Installation, Operation And Service Manual page 30

Panel removal
Top cover: Lift cover up and off Velcro strips.
splash panel
screw
Splash panel: Remove 2 screws. Pull out
bottom of panel to allow top to slide out from
under hopper support lip.
Fan removal
(a) Remove 4 fan mounting screws
and 3 drain tubes.
top cover
Front cover: Remove 2 screws. Lift cover up and
forward to unhook from keyhole slots and clear tabs on
bottom of cover.
hopper support lid
Side panels: Remove screw located on lower rear
side. Pull side panel toward front of unit and out of back
panel. Note: Before removing RH side, remove side
louver panel by lifting up and pulling forward on panel.
mounting
screws
(b) Rotate fan mounting bracket
toward back of unit and pull
fan assembly toward front of
unit.
30
front cover
screw
screw
left hand
side panel
(c) As fan assembly is being pulled
toward front, rotate assembly
clockwise as shown above.
back panel
right hand
side panel
screw
louver
panel