Installation Procedures; Installing Countertop Dispensers Without Legs - Follett C125A Installation, Operation And Service Manual

12 series ice and water dispensers

Hide thumbs

Table Of Contents

Table of Contents

• All dispensers must be installed level in both directions to ensure proper operation.

• Required service and ventilation clearances: 6" (153mm) on right side of dispenser, 12" (305mm) at top.

• Countertop units installed without legs provide the option of taking utilities out bottom or back of dispenser

(on wall mount units and countertop units with legs, utilities exit out back). See counter cut-out drawings

for bottom exiting utilities on units with and without drain pans. For installations where utilities exit through

back of dispenser, refer to back view drawings.

• Wall mount models without drain pan are designed for use above sinks.

• Wall mount models require 30" (762mm) deep counters. Front of sinks must be installed no more than 2"

(51mm) from front of counter.

Installing countertop dispensers without legs

Position dispenser in desired location,

mark dispenser outline on counter and

remove dispenser.

Regardless of whether utilities will exit

through back or bottom of dispenser, drill

four (4) 7/16" holes in counter to anchor

dispenser to counter (Fig. 1).

For utilities exiting through bottom

only:

(a) Make cutout as shown in Fig. 1.

(b) Move plug from drain T to back of

unit (Fig. 2).

fitting and poly tube.

(d) Run water line to 3/8" FPT water

inlet.

For all units:

Apply a thick bead - approximately 1/4"

(6 mm) diameter - of NSF listed silicone

sealant (Dow Corning RTV-732 or

equivalent) 1/4" (6mm) inside marked

outline of dispenser.

Carefully lower dispenser on counter in

proper position and secure to counter

with four (4) 3/8"-16NC bolts.

Smooth excess sealant around outside

of dispenser.

Make final connections.