Snmp Settings - Konica Minolta bizhub C550 User Manual

Network Settings
4.12

SNMP Settings

Specify SNMP settings. Settings can be specified for the following.
SNMP Setting screen 1/3
Parameter
SNMP v1/v2c (IP)
SNMP v3 (IP)
SNMP v1 (IPX)
SNMP Setting screen 2/3
Parameter
UDP Port Number
SNMP v1/v2c Settings
SNMP v3 Settings
SNMP Setting screen 3/3
Parameter
Permission Settings
TRAP Setting When Au-
thentication Failed
!
Detail
If an IP address or IPX address is specified with "Status Notification Set-
ting", use the TRAP function with SNMP. Set "TRAP Setting" on the
SNMP Setting screen to "Allow".
For details on "Status Notification Setting", refer to "Status Notification
Setting" on page 4-125.
1
Touch [5 Network Setting] in the Administrator Settings screen.
– For details on displaying the Administrator Settings screen, refer to
"Displaying the Administrator Settings screen" on page 3-7.
2
Touch [8 SNMP Settings] in the Network Settings screen.
SNMP Setting screen 1/3 appears.
C550
Description
Select whether or not SNMP v1/v2c (IP) is used.
Select whether or not SNMP v3 (IP) is used.
Select whether or not SNMP v1 (IPX) is used.
Description
Specify the UDP port number. To change the setting, press the [C]
(clear) key, and then use the keypad to type in the desired port
number. (Range: 1 to 65535)
Specify the settings when v1 or v2c is selected. For details, refer
to "SNMP v1/v2c Settings" on page 4-98.
Specify the settings when v3 is selected. For details, refer to
"SNMP v3 Settings" on page 4-100.
Description
Select whether to permit or prohibit TRAP.
Select whether or not to enable TRAP when authentication failed.
4
4-96