Konica Minolta 7235 Network Setup Manual page 204

Scan Quality
This changes the default value for the scanner resolution.
The factory default is [200 dpi].
1
Select [Scan Quality] in [Initial setting] screen.
When you touch the [
For details on the procedure for displaying the [Initial setting] screen, refer to [Switching the Key Operator Mode]
( Page 190).
2
Touch the [EDIT] key, then change the setting.
Each time you touch the [EDIT] key, the setting is switched.
Select the setting item from among the following.
[200 dpi] : The scanner resolution is set to 200 dpi.
[300 dpi] : The scanner resolution is set to 300 dpi.
[400 dpi] : The scanner resolution is set to 400 dpi.
[600 dpi] : The scanner resolution is set to 600 dpi.
3
Touch the [RETURN] key.
From now on, documents are scanned according to this setting.
] or [ ] key, the selection item is switched.
195
8-2. Scanner Initial Settings
IV Scanner Key Operator - Administrators only
Chapter 8 Key Operator Settings