Configuration Program - Planet WRT-413 User Manual

802.11g wireless broadband router
Table of Contents

Advertisement

Configuration Program

The WRT-413 contains an HTTP server. This enables you to connect to it, and configure it, using your Web
Browser that has support JavaScript.
The configuration program has been tested on the following browsers:
Netscape V4.08 or later
Internet Explorer V4 or later
Preparation
Before attempting to configure the WRT-413, please ensure that:
Your PC can establish a physical connection to the WRT-413. The PC and the WRT-413 must be directly
connected (using the LAN port on the WRT-413) or on the same LAN segment.
The WRT-413 must be installed and powered ON.
If the WRT-413's default IP address (192.168.0.1) is already used by another device, the other device must
be turned OFF until the WRT-413 is allocated a new IP Address during configuration.
Using UPnP
If your Windows system supports UPnP, an icon for the WRT-413 will appear in the system tray, notifying you
that a new network device has been found, and offering to create a new desktop shortcut to the newly-discovered
device.
Unless you intend to change the IP Address of the WRT-413, you can accept the desktop shortcut.
Whether you accept the desktop shortcut or not, you can always find UPnP devices in My Network Places
(previously called Network Neighborhood).
Double - click the icon for the WRT-413 (either on the Desktop, or in My Network Places) to start the
configuration. Refer to the following section
Using your Web Browser
To establish a connection from your PC to the WRT-413:
1. After installing the WRT-413 in your LAN.
2. Set your PC as a DHCP client and start. If your PC is already running, restart it.
3. Start your WEB browser.
4. In the Address field, enter "HTTP://" and the IP Address of the WRT-413, as in this example, which uses the
WRT-413's default IP Address:
HTTP://192.168.0.1
The default password is blank, so your will not be prompted for a password. However, you should assign a
password to your WRT-413. Please refer to the
Setup Wizard
for details of the initial configuration process.
Password
section later in this chapter for details.
9

Advertisement

Table of Contents
loading

Table of Contents