Planet WRT-413 User Manual page 28

Checking TCP/IP Settings - Windows 9x/Me:
1. Select Control Panel - Network. You should see a screen as below:
2. Select the TCP/IP protocol for your network card.
3. Click on the Properties button. You should then see a screen as below.
Ensure your TCP/IP settings are correct, as follows:
Using DHCP
To use DHCP, select "Obtain an IP Address automatically ". This is the default in Windows. Using this setting
is recommended. By default, the WRT-413 will act as a DHCP Server.
Restart your PC and ensure it obtains an IP Address from the WRT-413.
Using "Specify an IP Address"
If your PC is already configured, check with your network administrator before configure the following settings:
•
On the Gateway tab, enter the WRT-413's IP address in the New Gateway field and click Add. Your network
administrator can advise you of the IP address they had assigned to the WRT-413.
Figure 12: Network Configuration
Figure 13: IP Address (Win 95)
22