Manually Receiving Data - Konica Minolta bizhub 215 User Manual

3.14 Receiving data
3.14.5

Manually receiving data

This mode is useful when this machine is connected to an external phone and a single line is shared between
the phone and fax modes where it is used mainly in the phone mode. This mode allows you to receive a fax
document without hanging up after speaking with the sender.
Tips
-
1
2
3
bizhub 215
Downloaded From ManualsPrinter.com Manuals
Reception
After picking up the receiver and
speaking, press "Start" to begin
receiving the fax.
Manual RX is available when a phone is connected to the external phone connector of this machine. To
use manual RX, set [RX MODE] to [MANUAL RX] in the Utility screen. For details, refer to page 7-24.
When the phone rings, pick up the receiver and speak to the sender.
When you hear the sound "po, po, po" through the receiver after speaking, press the Start key.
Transmission starts.
% If the destination is set to the Auto TX mode, you may not hear the sound "po, po, po...".
% When necessary, you can switch to the fax receiving mode after receiving an incoming call through
an external phone.
Put down the receiver. When the receiving process ends, a "long beep" sounds.
The telephone continues to ring.
3
3-26