Table of Contents
Advertisement
ExpressCard assembly
Description
ExpressCard assembly
Before removing the ExpressCard assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Service cover (see
b.
Hard drive (see
c.
Optical drive (see
d.
WLAN module (see
e.
WWAN module (see
f.
Fan (see
g.
Keyboard (see
h.
Base enclosure (see
i.
System board (see
Remove the ExpressCard assembly:
1.
Release the ZIF connector (1) to which the ExpressCard assembly cable is attached, and then
disconnect the ExpressCard assembly cable from the TouchPad board.
2.
Release the ZIF connector (2) to which the TouchPad cable is attached, and then disconnect the
TouchPad cable from the ExpressCard assembly.
122
Chapter 4 Removal and replacement procedures
Battery on page
Service cover on page
Hard drive on page
Hard drive on page
WLAN module on page
WWAN module on page
Fan on page
90)
Keyboard on page
Base enclosure on page
System board on page
71), and then remove the following components:
74)
80)
80)
86)
84)
91)
96)
112)
Spare part number
684345-001
Advertisement
Table of Contents
