Maintenance Overview - Oce CS4236 User Manual

Maintenance Overview

Maintenance Overview
Introduction
About scanner maintenance Scanner maintenance will ensure optimal performance of
your scanner. There are three basic maintenance tasks.
Overview three basic maintenance tasks
Cleaning.
1.
Keep your scanner clean - the next section describes how to thoroughly clean the internal
scan area. How often you need to clean will depend on how often and the types of media
you scan. If your work primarily involves scanning newspapers and old blueprints you
may need to clean more often than users who only scan brochures and new drawings. Be
sure to clean the scanner when results are not optimal. Particles of dust in the scan area
can sometimes be the sole cause of streaks in the end result. See more under the section
Cleaning the scan area.
Calibration
2.
Calibrate the scanner if your output is not optimal and cleaning (above) does not remedy
the problem. Calibration will renew the scanner's original color and BW precision.
Scanner Calibration is easy to perform. To run, you insert a Calibration Sheet, and start
the Scanner Maintenance program. The rest is done by the program. Make sure the
scanner is clean before calibrating. See
page 49
Replacing the glass plate.
3.
This should be carried out when a worn glass plate affects your results. You may need a
new glass plate if streaks still appear on the image even after cleaning the glass. See
ing the glass plate' on page 52
Request a replaceable part at mediaguide.oce.com.
40 Chapter 7 - Maintenance
'Calibration - Scanner Maintenance program' on
'Replac-