Removing A Slim Optical Drive - HP EliteDesk 800 G1 Tower Service Manual

6.
If installing a USB 3.0 media card reader, connect the USB cable from the media card reader to
the USB 3.0 connector on the system board labeled MEDIA3.0.
NOTE:
drive connectors.

Removing a slim optical drive

CAUTION:
computer.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Remove the front bezel
4.
Disconnect the power cable and data cable from the back of the drive.
CAUTION:
avoid damaging the cable.
Refer to System board connections on page 57
All removable media should be taken out of a drive before removing the drive from the
(Access panel on page
(Front bezel on page
When removing the cables, pull the tab or connector instead of the cable itself to
for an illustration of the system board
(Preparation for disassembly on page
45)
47)
44)
Drives
67