Bezel Blanks - HP EliteDesk 800 G1 Tower Service Manual

Bezel blanks

Description
Optical drive 5.25-inch bezel blank
On some models, there are bezel blanks covering the 3.5-inch and 5.25-inch drive bays that need to
be removed before installing a drive. To remove a bezel blank:
1.
Remove the access panel
2.
Remove the front bezel
3.
Remove the bezel blank for the appropriate drive:
To remove a 5.25-inch bezel blank, press inward on the retaining tabs that hold the bezel
●
blank in place (1) then pull the bezel blank from the front bezel (2).
NOTE:
install an optional bezel trim piece (available from HP) that surrounds the front of the drive.
48 Chapter 5 Removal and replacement procedures: Tower (TWR)
(Access panel on page
(Front bezel on page
After removing the 5.25-inch drive bezel blank and installing a drive, you can
45)
47)
Spare part number
732770-001