Power Switch - HP EliteDesk 800 G1 Tower Service Manual

Power switch

Description
Power switch
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Remove the optical drive
5.
Remove the hard drive
6.
Remove the drive cage
7.
Disconnect the power switch cable from the system board connector labeled PB/LED.
8.
Remove the power switch cable from atop the front I/O bracket.
9. From the front of the computer, press down (or squeeze) on the top on the power switch (1), and
then rotate it down (2) to disengage it from the chassis.
10.
Pull the power switch and cable assembly out through the hole in the front of the chassis.
To install the power switch, reverse the removal procedure.
170 Chapter 7 Removal and replacement procedures: Ultra-slim Desktop (USDT)
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page 143).
(Removing the optical drive on page
(Hard drive on page 154).
(Drive cage on page 164).
142).
151).
Spare part number
732767-001
141).