Hood Sensor - HP EliteDesk 800 G1 Tower Service Manual

Hood sensor

Description
Hood sensor
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the optical drive
4.
Remove the hard drive
5.
Remove the drive cage
6.
Remove the optical drive
7. Unplug the hood sensor cable from the white system board connector labeled HSENSE (1) and
remove the cable from the white clip mounted on the inside chassis wall (2).
8. Slide the hood sensor into the chassis to remove it from its slot (3). Disengaging the hood sensor
from the chassis may require use of a screwdriver or similar tool.
To install the hood sensor, reverse the removal procedures.
(Preparation for disassembly on page
(Access panel on page
(Removing the optical drive on page
(Hard drive on page 154).
(Drive cage on page 164).
(Removing the optical drive on page
142).
151).
151).
Spare part number
638816-001
141).
Hood sensor
165