The Zoom Behavior - Canon imagePRESS C7011VPS series Operation Manual

The zoom behavior

Introduction
When you carry out a copy job or scan job, you can use the Zoom function to reduce or enlarge
an image, for example:
• Copy an A4 / LTR original on an A3 / 11"x 17" sheet. The system enlarges the image
• Copy an A3 / 11"x 17" original on an A4 / LTR sheet. The system reduces the image
• Copy an A4 / LTR original with a small illustration on an A4 / LTR sheet, and at the same time
enlarge the illustration.
By factory default, the zoom function is set to Fit to page. This makes sure that no information is
lost. To change the zoom factor manually, touch the - and + buttons of the Zoom function in the
job window. If you use non-standard size originals, you must use the glass plate.
The zoom function for originals in the automatic document feeder is different from the zoom
function for originals on the glass plate.
Zoom behavior
Original
Automatic document feeder
Glass plate
This section describes the characteristics of the zoom function when you use the automatic
document feeder or the glass plate.
NOTE
The zoom function works identical for both copy jobs and scan jobs.
Scan from the automatic document feeder and use the zoom function
The following table shows the zoom behavior of the machine when the originals are scanned
from the automatic document feeder. The focus is on the centre of the original.
Scan from the automatic document feeder using the zoom function
Illustration
NOTE
The center of the image is fixed.
Starting point of the zoom function
Center
Upper left-hand corner
Description
The original is placed face up and in readable form into the auto-
matic document feeder.
The center of the original is a fixed point and is used as the origin
of the image.
Result of a scan with a 100% zoom factor.
Result of a scan with a 50% zoom factor.
The zoom behavior
Chapter 9 - Carry out copy jobs
4
249