Change The Print Delivery Settings - Canon imagePRESS C7011VPS series Operation Manual

Change the print delivery settings

Introduction
Usually the print delivery settings have been defined in the printer driver.
Overview of the print delivery settings
Setting
[Output location]
[Sort]
[Offset stacking]
[Advanced settings]
Procedure
1. Touch [Jobs] -> [Waiting jobs], or select a [DocBox].
2. Touch the job of which you want to change the settings.
NOTE
You can only change the settings of the active print job
[Stop] button
3.
Press [Properties].
4. Touch the [Print delivery].
5. Make the required changes.
6. Press [OK].
7.
Press [OK].
Description
Change the output location for the job. The list shows all the out-
put locations that are available for your system.
Make sure there is a match between the selected output location
and the job requirements. For example, when a job requires sta-
ples, you must select an output location that allows stapling.
Change the sorting method of the prints. You can select sort [By
page] or [By set].
[55] Sort by page
[56] Sort by set
Stack the prints with an offset.
This setting is only available when the [Offset stacking] setting of
the active [Workflow profile] is set to [Sets (as in job)].
Finishing equipment often requires that the printed sheets are de-
livered in a certain order. For finishers that are integrated in your
printing system, the required settings are adapted automatically.
However, sometimes it can be necessary to change a number of
settings manually, for example when you want to finish the prints
using offline finishers. If required, you can change the [Sheet or-
der], [Sheet orientation], [Print order] and [Rotation].
two times).
Change the print delivery settings
after you stopped the printer (press the
Chapter 8 - Carry out print jobs 197