Life Fitness Model 97Ti, 95Ti, 93T, 97Te, and 95Te Treadmills
How To... Replace the Smart Stop Circuit Board
Special Service Tools Required: NONE
Note: The Circuit Board and Foam Backing are part of the Smart Stop Cover Assembly. The illustration below
shows an exploded view of these components for clarity purposes only.
Smart Stop
Cover Assembly
1. Turn the unit power OFF at the switch then unplug the line cord at the wall outlet.
2. Remove two screws from the back of the ERGO Bar securing the Smart Stop Cover Assembly, and then lift off
the Smart Stop Cover just enough to disconnect the 4-Pin Connector from the Smart Stop Circuit Board.
3. Remove and discard the Smart Stop Assembly.
4. Install new Smart Stop Assembly in reverse order.
ERGO Bar
Handrail
Smart Stop
Circuit Board
(Part of the Smart
Stop Cover Assembly)
42
Mounting
Screws
Foam Backing
(Part of the Smart
Stop Cover Assembly)