Mounting And Dismounting The User Position; Using And Testing The Emergency Stop - Life Fitness INT-SSE4 Assembly Instructions Manual

Hide thumbs Also See for INT-SSE4:
Table of Contents

Advertisement

Mounting and Dismounting the Unit
Use the handrails to enhance stability when mounting or dismounting the unit. Never mount or dismount the unit while
the running belt is moving. Use the STOP button on the console to end a workout and stop the running belt. Use the
Emergency Stop System to stop the belt immediately.
User Position
The width of the moving walking/running surface is 22 in. (55 cm). Users must keep their feet within this width while
in motion. If standing on the stationary side rails, a user should ensure that his/her feet are completely on the non-
moving portion. Never step partially on the moving surface and partially on the non-moving surface simultaneously.
• Users can adjust their fore-aft position on the moving belt as desired for reach to the console and handles,
clearance for arm swing and attachment of the safety stop pull cord. Do not step on the rear roller.
• It is recommended that the user run within the length of the side handrails to allow usage of the side arms to
dismount the belt if needed.
Using and Testing the Emergency Stop System
The treadmill is equipped with an Emergency Stop System. The system consists of a rectangular stop magnet (located
on the upper bridge plastic) attached to a safety stop pull cord.
Before starting a workout, attach the lanyard on the safety stop pull cord to an item of the user's clothing. During a
workout, pull the cord to remove the magnet from the bridge. This will immediately stop the treadmill belt.
NOTE: Test the safety stop pull cord by attaching the lanyard to a user's item of clothing during operation of the
treadmill. While the treadmill is on and the console display is active, remove the safety stop pull cord / magnet from
the bridge. A message will be displayed on the console similar to "Replace the emergency stop switch". With the
safety stop pull cord removed no keys shall function on the treadmill. Place the safety stop pull cord back in place. The
treadmill will reset and will be ready for operation.
Page 15 of 45

Advertisement

Table of Contents
loading

Table of Contents