Ubee DVW3201B Subscriber User Manual page 14

Understanding LED Operations
LED Color
BATTERY White
Ethernet 1-4 Orange/
(back panel) Green
WPS button White
(top of
device)
eMTA INITIALIZATION
AC POWER
NORMAL (AC
POWER IS ON)
eMTA NORMAL
OPERATION
10
On – The battery is installed and AC power is on and properly functioning.
Off – If there is no AC power to the device, the Battery LED is Off, the Power LED flashes,
and the TEL1 LED is On. All other LEDs are Off.
Blinks – If the battery is at low power level (30mins left).
On ORANGE – When an Ethernet device is connected to the cable modem at 10/100 Mbps
speeds,
On GREEN – When an Ethernet device is connected to the cable modem at 1000 speeds
(Gigabit Ethernet).
Blinks (in ORANGE or GREEN) – When data is passed between the cable modem and the
connected device.
The Ethernet ports are used to connect Ethernet devices, such as computers, gaming
consoles, and/or routers/hubs to the DVW3201B using RJ45 cables. Each Ethernet port on
the back panel of the device has an LED to indicate its status when an Ethernet device is
connected.
Located on top of the cable modem, this button is used for the WiFi Protected Setup (WPS)
method to connect a PIN-protected WiFi device to the cable modem.
When a user pushes the WPS button or triggers WPS via the device's Web UI, an LED on
the top-front of the device blinks for 4 minutes until a PIN is entered from the wireless client
that wishes to connect (for example, a laptop computer). After a WiFi client attaches
successfully, the LED remains On for 5 minutes, then turns Off. Refer to
Wireless Menu on page 57
DESIGNATION/LABEL
1
STEP
2
MTA SNMP/TFTP
3
Ubee DVW3201B Advanced Wireless Voice Gateway Subscriber User Guide • July 2012
Description
for more information.
LED POSITION LED1
LED
POWER
ON
MTA DHCP
ON
ON
RSIP
On-Hook
ON
Off-Hook
Ubee Interactive
Understanding the
LED2 LED3
US/DS ONLINE
ON ON
ON ON
ON ON
ON =
NETWORK
AVAILABLE
ON
OFF =
NETWORK
NOT
AVAILABLE
LED4
WiFi
ON