Advertisement
Quick Links
DVW324 D3.0 Advanced Wireless Voice Gateway Safety and Installation Product Insert
◆ Federal Communications Commission
(FCC) Interference Statement
This device has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
device generates, uses, and can radiate radio
frequency energy. If not installed and used in
accordance with the instructions, the device may
cause harmful interference to radio communications.
There is no guarantee, however, that interference
will not occur in a particular installation. If this device
causes harmful interference to radio or television
reception, which can be determined by turning it off
and on, the user can try to correct the interference
by one of the following measures:
• Increase the separation between the device and
the equipment with which it is interfering (for
example, a television or radio).
• Connect the device to an electrical outlet on a
different circuit than the interfered device is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
◆ FCC Regulatory Information
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference
received, including interference that may cause
undesired operation. (3) There are two statements
for this product:
• Only the type of Metal PIFA antenna tested may
be used.
• The device must carry a label stating "FCC ID:
XCNDVW324."
FCC Caution: Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to operate
this device.
IEEE 802.11b or 802.11g operation of this device in
the U.S.A. is firmware-limited to channels 1 through
11.
For operation within 5.15 ~ 5.25GHz frequency
range, it is restricted to indoor environment. This
device meets all the other requirements specified in
Part 15E, Section 15.407 of the FCC Rules.
◆ FCC Radiation Exposure Statement
This device complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
1
Advertisement
Related Manuals for Ubee DVW324
Summary of Contents for Ubee DVW324
- Page 1 DVW324 D3.0 Advanced Wireless Voice Gateway Safety and Installation Product Insert ◆ FCC Regulatory Information ◆ Federal Communications Commission This device complies with Part 15 of the FCC Rules. (FCC) Interference Statement Operation is subject to the following two conditions: This device has been tested and found to comply (1) This device may not cause harmful interference.
- Page 2 device should be installed and operated at a Fasten two screws horizontally to the wall at a minimum distance of 20 cm between itself and your distance of 19.4 cm (7.63”). Allow screws to body. project from the wall so the device hangs securely This device must not be co-located or operating in on the screws.
- Page 3 tighten the cables as this may strain the connector and cause damage. Figure 2: Screw Size Figure 3: Connection Diagram 2. Connect one end of the Ethernet cable (included) • Place the device near an outlet so the AC power to one of the Ethernet ports (ETH1 –...
- Page 4 4. Connect the power adapter to the POWER port COLOR DESCRIPTION on the device. Plug the other end of the power • Blue - more than one channel adapter into the AC wall outlet. Important: Use bonded. only the power adapter that is shipped with the LED blinks during firmware device.
- Page 5 Figure 4: Front Panel LEDs...