Download Print this page
Ubee DVW32G6 Safety And Installation
Ubee DVW32G6 Safety And Installation

Ubee DVW32G6 Safety And Installation

Advanced wireless voice gateway

Advertisement

Quick Links

Ubee Interactive — www.ubeeinteractive.com
DVW32G6 Advanced Wireless Voice
Gateway - Safety and Installation
Product Insert
Federal Communications Commission
(FCC) Interference Statement
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy and,
if not installed and used in accordance with the
instructions, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct the interference by one of the
1
Ubee DVW32G6 – Safety and Installation Product Insert v1.0
following measures:
Reorient or relocate the receiving antenna
Increase the separation between the
equipment and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
FCC Regulatory Information
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
There is one statement for this product:
• Only the type of PCB antenna tested may be

Advertisement

loading

Summary of Contents for Ubee DVW32G6

  • Page 1 There is one statement for this product: the equipment off and on, the user is encouraged • Only the type of PCB antenna tested may be to try to correct the interference by one of the Ubee DVW32G6 – Safety and Installation Product Insert v1.0...
  • Page 2: Fcc Radiation Exposure Statement

    This device should be installed and 4. Do not place the device near heat sources operated at a minimum distance of 28cm such as radiators or stoves. between itself and your body. Ubee DVW32G6 – Safety and Installation Product Insert v1.0...
  • Page 3 AC wall outlet immediately. 9. The device should be installed in a location not to exceed the maximum temperature of degrees Celsius (104 degrees Fahrenheit). Ubee DVW32G6 – Safety and Installation Product Insert v1.0...
  • Page 4 Category 5e or Category 6 Ethernet cables with RJ-45 connectors must be used when connecting Ethernet devices to the LAN ports. This ensures Gigabit Ethernet speeds (unless the computer does not support it). Ubee DVW32G6 – Safety and Installation Product Insert v1.0...
  • Page 5 A 6.65+/-0.35 2. Remove the device from the product package. B 1.9+/-0.15 C 19.0+/1.20 3. Mount the device on the wall. 4. Refer to the following figure. The Screw’s Size (mm) Ubee DVW32G6 – Safety and Installation Product Insert v1.0...
  • Page 6: Additional Information

    DEVICE. Refer to the User Manual for more initializes, the LED flashes. information. When the device locks on to channels and registers OK, the LED is On. When the device performs a firmware upgrade, the LED flashes. Ubee DVW32G6 – Safety and Installation Product Insert v1.0...
  • Page 7 LED is Off if no battery is installed. If the battery is at low power level (30mins left), the battery LED will flash. WPS (top of device)—If not used, the LED is Off. Ubee DVW32G6 – Safety and Installation Product Insert v1.0...
  • Page 8 LED is Green when connected at 1000 Mbps speeds (Gigabit Ethernet). • When data is being passed between the device and the connected device, the LED flashes. Ubee DVW32G6 – Safety and Installation Product Insert v1.0...