Table 27-2 Menu 4 Internet Access Setup - ZyXEL Communications Prestige 662HW Series User Manual

FIELD
ISP's Name Enter the name of your Internet Service Provider. This information is for
identification purposes only.
Encapsulation
Press [
your ISP. Choices are PPPoE, PPPoA, RFC 1483 or ENET ENCAP.
Multiplexing
Press [
ISP. Choices are VC-based or LLC-based.
VPI # Enter the Virtual Path Identifier (VPI) assigned to you.
VCI # Enter the Virtual Channel Identifier (VCI) assigned to you.
ATM QoS Type Press [SPACE BAR] and select CBR (Continuous Bit Rate) to specify
fixed (always-on) bandwidth. Select UBR (Unspecified Bit Rate) for
applications that are non-time sensitive, such as e-mail. Select VBR
(Variable Bit Rate) for bursty traffic and bandwidth sharing with other
applications.
Peak Cell Rate This is the maximum rate at which the sender can send cells. Type the
(PCR) PCR.
Sustain Cell Rate Sustained Cell Rate is the mean cell rate of a bursty, on-off traffic source
(SCR)= 0 that can be sent at the peak rate, and a parameter for burst-traffic. Type
the SCR; it must be less than the PCR.
Maximum Burst Refers to the maximum number of cells that can be sent at the peak rate.
Size (MBS)= 0 Type the MBS. The MBS must be less than 65535.
My Login Configure the My Login and My Password fields for PPPoA and PPPoE
encapsulation only. Enter the login name that your ISP gives you. If you
are using PPPoE encapsulation, then this field must be of the form
user@domain where domain identifies your PPPoE service name.
My Password Enter the password associated with the login name above.
ENET ENCAP Enter the gateway IP address supplied by your ISP when you are using
Gateway ENET ENCAP encapsulation.
Idle Timeout This value specifies the number of idle seconds that elapse before the
Prestige automatically disconnects the PPPoE session.
IP Address
Press [
Assignment
IP Address Enter the IP address supplied by your ISP if applicable.
Network Address
Press [
Translation
Please see the NAT Chapter for more details on the SUA (Single User
Account) feature.
Address Type the numbers of mapping sets (1-8) to use with NAT. See the NAT
Mapping Set chapter for details.
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to cancel" to
save your configuration or press [ESC] to cancel and go back to the previous screen.
If all your settings are correct your Prestige should connect automatically to the Internet. If the
connection fails, note the error message that you receive on the screen and take the appropriate
troubleshooting steps.
Internet Access

Table 27-2 Menu 4 Internet Access Setup

DESCRIPTION
SPACE BAR
] to select the method of encapsulation used by
SPACE BAR
] to select the method of multiplexing used by your
SPACE BAR
] to select Static or Dynamic address assignment.
SPACE BAR
] to select None, SUA Only or Full Feature.
Prestige 662HW Series User's Guide
MyIsp
ENET ENCAP
LLC-based
8
32
UBR
0
0
0
N/A
N/A
N/A
0
Dynamic
N/A
SUA Only
N/A
EXAMPLE
27-5