Dtr Signal; Response Strings; Configuring Advanced Modem Setup; Figure 7-7 Advanced Modem Setup - ZyXEL Communications Prestige 662HW Series User Manual

Prestige 662HW Series User's Guide
For ISDN lines, there are many more protocols and operational modes. Please consult the
documentation of your TA. You may need additional commands in both "Dial" and "Init" strings.

7.11 DTR Signal

The majority of WAN devices default to hanging up the current call when the DTR (Data Terminal
Ready) signal is dropped by the DTE. When the "Drop DTR When Hang Up" check box is selected,
the Prestige uses this hardware signal to force the WAN device to hang up, in addition to issuing the
drop command "ATH".

7.12 Response Strings

The response strings tell the Prestige the tags, or labels, immediately preceding the various call
parameters sent from the WAN device. The response strings have not been standardized; please
consult the documentation of your WAN device to find the correct tags.

7.13 Configuring Advanced Modem Setup

To configure settings for your backup WAN modem, click WAN, WAN Backup and then the
Advanced Setup button. The Advanced Setup screen displays, click the Edit button to open the
Advanced Modem Setup screen as shown next.
Consult the manual of your WAN device connected to your dial
backup port for specific AT commands.
Figure 7-7
Advanced Modem Setup
The following table describes the fields in this screen.
WAN Setup 7-13