Table 25-2 Tcp/Ip Ethernet Setup - ZyXEL Communications Prestige 662HW Series User Manual

FIELD
Client IP Pool Starting
Address
Size of Client IP Pool
Primary DNS Server
Secondary DNS Server
Remote DHCP Server
Follow the instructions in the following table to configure TCP/IP parameters for the Ethernet port.
FIELD
TCP/IP Setup
IP Address Enter the (LAN) IP address of your Prestige in dotted decimal notation 192.168.1.1
IP Subnet Mask Your Prestige will automatically calculate the subnet mask based on
the IP address that you assign. Unless you are implementing
subnetting, use the subnet mask computed by the Prestige.
RIP Direction
Press [
In Only, Out Only or None.
Version
Press [
RIP-2B or RIP-2M.
Multicast IGMP (Internet Group Multicast Protocol) is a network-layer protocol
used to establish membership in a Multicast group. The Prestige
supports both IGMP version 1 (IGMP-v1) and version 2 (IGMP-v2).
Press the [
disable it.
IP Policies Create policies using SMT menu 25 (see the IP Policy Routing
chapter) and apply them on the Prestige LAN interface here. You can
apply up to four IP Policy sets (from twelve) by entering their numbers
separated by commas.
Edit IP Alias The Prestige supports three logical LAN interfaces via its single
physical Ethernet interface with the Prestige itself as the gateway for
each LAN network. Press [
press [
Menu 3 LAN Setup
Table 25-1 DHCP Ethernet Setup
This field specifies the first of the contiguous addresses in the IP
address pool.
This field specifies the size or count of the IP address pool.
Enter the IP addresses of the DNS servers. The DNS servers are
passed to the DHCP clients along with the IP address and the subnet
mask.
If Relay is selected in the DHCP field above then enter the IP address
of the actual remote DHCP server here.

Table 25-2 TCP/IP Ethernet Setup

DESCRIPTION
SPACE BAR
] to select the RIP direction. Choices are Both,
SPACE BAR]
to select the RIP version. Choices are RIP-1,
SPACE BAR]
to enable IP Multicasting or select None to
SPACE BAR
ENTER
] to display menu 3.2.1.
Prestige 662HW Series User's Guide
DESCRIPTION
] to change No to Yes and
EXAMPLE
192.168.1.33
32
EXAMPLE
255.255.255.0
Both
(default)
RIP-1
(default)
None
(default)
2,4,7,9
No
(default)
25-3