Programming ''Wake Up'' (Wake Up Time) Into Unit; Programming Point Of Sale Message Display; Adjusting "Vis Set" (Product Viscosity) Of Dispensed Product - Cornelius FCB 3 H.P. POST-MIX DISPENSER Installation & Service Manual

4. After hour (time of day) has been locked in on message display, minute numbers will be flashing on display.
Press ''CANCEL DEFROST'' (ADVANCE) switch to advance minute numbers to desired minutes (time of
day). Press ''DEFROST'' (SELECT) switch to lock in minutes (time of day) on display.
5. Press ''ERROR RESET'' switch two times to exit from MENU SELECTIONS.

PROGRAMMING ''WAKE UP'' (WAKE UP TIME) INTO UNIT

''WAKE UP'' (WAKE UP TIME) may be programmed into Unit to occur any time of the day to wake Unit up
(return to normal operation) after ''sleep time'' has occurred. Program ''WAKE UP'' into Unit as follows:
1. Refer to PROGRAMMING MAIN MENU SELECTIONS ONTO MESSAGE DISPLAY and bring up ''WAKE
UP'' on message display. Press ''DEFROST'' (SELECT) switch to lock in on selection.
2. Press ''CANCEL DEFROST'' (ADVANCE) switch to advance hours on display to desired hour. Press
''DEFROST'' (SELECT) switch to lock in hour on display.
3. After hour (time of day) has been locked in on message display, minute numbers will be flashing on display.
Press ''CANCEL DEFROST'' (ADVANCE) switch to advance minute numbers to desired minutes (time of
day). Press ''DEFROST'' (SELECT) switch to lock in minutes (time of day) on display.
4. Press ''CANCEL DEFROST'' (ADVANCE) switch to bring up flashing hour number on display.
5. Press ''ERROR RESET'' switch two times to exit from MENU SELECTIONS.

PROGRAMMING POINT OF SALE MESSAGE DISPLAY

(see Figure 10 and TABLE 6)
Note: Point of sale display messages may be turned off by placing No. 1 DIP SWITCH on master circuit
board in "OFF" position and No. 2 DIP SWITCH in "ON" position (see Figure 10 and 4 and 6) assembly
in appropriate positions.
Three point of sales display messages are available and the desired one may be programmed in to appear on
the message display by placing No. 1 and No. 2 switches (see Figure 10 and TABLE 4 and TABLE 6) on the
DIP SWITCH ASSEMBLY in the appropriate positions.

ADJUSTING "VIS SET" (PRODUCT VISCOSITY) OF DISPENSED PRODUCT

Adjusting "VIS SET" (PRODUCT VISCOSITY) determines what product consistency of the dispensed product
will be present in each freeze cylinder. Adjust "VIS SET" (PRODUCT VISCOSITY) of the dispensed product as
follows.
1. Refer to PROGRAMMING MAIN MENU SELECTIONS INTO MESSAGE DISPLAY and bring up "VIS
SET" on message display.
2. Press "DEFROST" (SELECT) switch to bring up numbers on message display.
Note: The direction of arrows (% &) on message display indicates which set of numbers belongs to
which freeze cylinder. A No. 4 setting indicates the thinnest product consistency of dispensed product
and a No. 12 setting indicates the thickest consistency of product dispensed.
3. Press "CANCEL DEFROST" (ADVANCE) switch. The left-side freeze cylinder viscosity number will be
flashing on message display.
4. Press ''CANCEL DEFROST'' (ADVANCE) switch to advance viscosity number to desired setting. Press
''DEFROST'' (SELECT) switch to lock in viscosity setting. The right-side freeze cylinder viscosity number
will now be flashing.
43
312026000