Adjusting ''Vis Set'' (Product Viscosity) Of Dispensed Product; Vis Read" (Actual Viscosity Readout) Of Product In Freeze Cylinders; Displayed Evaporator Refrigeration Coils Inlets And Common Outlet Sensors Temperatures; Voltage'' (Displayed Voltage Readout) - Cornelius FCB 3 H.P. POST-MIX DISPENSER Installation & Service Manual

ADJUSTING ''VIS SET'' (PRODUCT VISCOSITY) OF DISPENSED PRODUCT

Adjust ''VIS SET'' (PRODUCT VISCOSITY) determines what product consistency of the dispensed product will
be present in each freeze cylinder. Adjust ''VIS SET'' (PRODUCT VISCOSITY) of the dispensed product as
instructed in SERVICE AND MAINTENANCE section.

"VIS READ" (ACTUAL VISCOSITY READOUT) OF PRODUCT IN FREEZE CYLINDERS

"VIS READ" (actual viscosity readout) may be brought up on the message display to actually read the viscosity
(product consistency) of product in the freeze cylinders while the Unit is in operation as instructed in SERVICE
AND MAINTENANCE section.
DISPLAYED EVAPORATOR REFRIGERATION COILS INLETS AND COMMON OUTLET
SENSORS TEMPERATURES
Evaporator refrigeration coils inlet and common outlet temperature readings in degrees Fahrenheit may be
displayed on the message display as instructed in SERVICE AND MAINTENANCE section.

''VOLTAGE'' (DISPLAYED VOLTAGE READOUT)

Displayed voltage readout may be displayed on the message display as instructed in SERVICE AND
MAINTENANCE section.

PROGRAMMING COMPONENTS ''DIAGNOSE'' (DIAGNOSTIC MODE) INTO the UNIT

''DIAGNOSE'' (DIAGNOSTIC MODE) may be programmed into the Unit to check certain components for
operation. Program ''DIAGNOSE'' into Unit the and check components for proper operation as instructed in
SERVICE AND MAINTENANCE section.
DISPLAYING ''TOTALS'' (DISPLAYED CYCLES AND HOURS TOTALS) ONTO the
MESSAGE DISPLAY
''TOTALS'' (DISPLAYED CYCLES AND HOURS TOTALS) may be displayed on the message display as
instructed in SERVICE AND MAINTENANCE section.

PROGRAMMING FREEZE CYLINDERS BEATER "MOTORS" INTO UNIT ELECTRONICS

IMPORTANT: Note in TABLE 5 MOTOR SELECT the number of freeze cylinders beater drive motors
Manufacturer's that are listed. Your Unit was manufactured and equipped with freeze cylinders beater
drive motors from one of these Manufacturer's. The beater motors were programmed at the factory to
match the Unit electronics. THE BEATER MOTORS PROGRAMMING MUST BE RE-CHECKED AT THE
TIME OF UNIT INSTALLATION as instructed in "PROGRAMMING FREEZE CYLINDERS BEATER
MOTORS INTO UNIT ELECTRONICS" in SERVICE AND MAINTENANCE section.

PROGRAMMING PROPER REFRIGERANT TYPE INTO UNIT ELECTRONICS

The Dispenser electronics must be programmed for the proper refrigeration pulse rate according to the type of
refrigerant gas that has been installed in the refrigeration system. Note Dispenser serial plate for the type of
refrigerant gas that has been installed, then proceed to SERVICE AND MAINTENANCE section for
programming instructions.
312026000
14