Installing Sound Baffle/Drip Tray Ass'y On Unit; Cylinder; Regulator Assembly; Preparing Unit Syrup Inlet Lines For Connection To Soft Drink Tanks - Cornelius FCB 3 H.P. POST-MIX DISPENSER Installation & Service Manual

Note: An alternate to sealing the Unit base to the floor would be to install the available 4-inch Caster Kit
(P/N 309570000).
2. After Unit has been placed in operating location, make sure it is sitting in a level position.
3. To comply with National Sanitation Foundation (NSF) requirements, Unit installed with base contacting floor
must have base sealed to floor with Dow Corning RTV 731 or equivalent.

INSTALLING SOUND BAFFLE/DRIP TRAY ASS'Y ON UNIT

All parts for the SOUND BAFFLE/DRIP TRAY ASS'Y (item 8) are shipped with the Dispenser in a separate
box. Refer to Installation Instructions provided with the Sound Baffle/Drip Tray Assembly and install as
instructed.
INSTALLING PRIMARY CO
(see Figure 2)
WARNING: To avoid personal injury and/or property damage, always secure CO
upright position with a safety chain to prevent it from falling over. Should the valve become
accidentally damaged or broken off, CO
WARNING: CO
CO (carbon dioxide) gas leaks in the entire CO
2
suspected, particularly in a small area, immediately ventilate the contaminated area before
attempting to repair the leak. Personnel exposed to high concentration of CO
tremors which are followed rapidly by loss of consciousness and suffocation.
1. Unscrew protector cap (with chain attached) from CO
counterclockwise to blow any dirt or dust from outlet fitting before installing primary CO
close valve.
2. Remove shipping plug from primary CO
inside nut. Install regulator assembly on CO
nut. DO NOT OPEN CO
CONNECTING SOFT DRINK TANKS CO
ASSEMBLY
(see Figure 2)
1. Connect soft drink tanks CO
2. Install gas quick disconnects on ends of soft drink tanks CO
TANKS AT THIS TIME.

PREPARING UNIT SYRUP INLET LINES FOR CONNECTION TO SOFT DRINK TANKS

(see Figure 2)
1. Route Unit syrup inlet lines, labeled No. 1 and No. 2, out through hole provided in the Unit base to the soft
drink tanks location.
312026000
REGULATOR ASSEMBLY ON CO
2
displaces oxygen. Strict attention must be observed in the prevention of
2
regulator assembly coupling nut and make sure gasket is in place
2
cylinder so gages can be easily read, then tighten coupling
2
CYLINDER VALVE AT THIS TIME.
2
2
lines to primary CO
2
cylinder can cause serious personal injury.
2
and soft drink system. If a CO
2
cylinder valve. Open CO
2
LINES TO PRIMARY CO
regulator manifold assembly as shown in Figure 2.
2
lines. DO NOT CONNECT CO
2
8

CYLINDER

2
cylinder in
2
gas leak is
2
gas will experience
2
cylinder valve slightly
2
regulator, then
2
REGULATOR
2
LINES TO
2