This section covers unpacking and inspection, installing LOOSE-SHIPPED PARTS, selecting location, installing
Unit, preparing for operation, and operation.
UNPACKING AND INSPECTION
(see Figure 4)
NOTE: The Unit was thoroughly inspected before leaving the factory and the carrier has accepted and
signed for it. Any damage or irregularities should be noted at time of delivery (or not later than 15 days
from date of delivery) and immediately reported to the delivering carrier. Request a written inspection
report from Claims Inspector to substantiate any necessary claim. File claim with the delivering carrier,
not with IMI Cornelius Inc.
1. After Unit has been unpacked, remove shipping tape and other packing material.
2. Remove Unit sides, top and back panels as instructed.
3. Unpack LOOSE-SHIPPED PARTS. Make sure all items are present and in good condition.
IDENTIFICATION OF LOOSE-SHIPPED PARTS
1. TAPERED GASKETS, WHITE (item 1) are used to seal connections when connecting Unit product inlet
lines to product tanks and connecting Unit CO
2. SPANNER WRENCH, DISPENSING VALVE (item 2) is used to remove shank nuts securing dispensing
valves to faceplates.
3. CLEANING BRUSH (item 3) is used to clean faceplate relief valves passages.
Item No.
1
178025100
2
322859000
3
325216000
4
311304000
5
2899
6
3810
7
325018000
8
XXXX
Note: All parts for the Sound Baffle/Drip Tray Assembly are shipped with the Dispenser in a separate
box and must be installed on the Dispenser. Refer to Installation Instructions provided with the Sound
Baffle/Drip Tray Assembly for installation procedure.
4. TAPERED GASKET, BLACK (item 4) is used to seal connection when connecting plain water source line to
Unit water inlet line.
5. WRENCH, REAR SEAL HOUSING (item 5) used to remove the drive shaft/seal assembly from inside the
freeze cylinder.
6. TOOL, DRIVE/COUPLER ADJUSTMENT GAUGE (item 6) is used for servicing the beater motor drive
shaft/seal assembly (see Figure 7).
312026000
INSTALLATION
Table 2. Loose-Shipped Parts
Part No.
Tapered Gasket, White
Spanner Wrench, Dispensing Valve
Cleaning Brush
Tapered Gasket, Black
Wrench, Rear Seal Housing
Tool, Drive/Coupler Adjustment Gauge
Caster Kit, 4-inch diameter Casters
Sound Baffle/Drip Tray Ass'y (see NOTE)
inlet line to CO
source.
2
2
Name
6
Qty.
4
1
1
3
1
1
1
1