Mac Filter Screen - ZyXEL Communications NBG6616 User Manual

Table 36 Network > Wireless LAN 2.4G/5G > More AP: Edit (continued)
LABEL
Enable
Bandwidth
Management
for Guest
WLAN
Maximum
Bandwidth
Security Mode
Apply
Cancel

11.5 MAC Filter Screen

The MAC filter screen allows you to configure the NBG6616 to give exclusive access to devices
(Allow) or exclude devices from accessing the NBG6616 (Deny). Every Ethernet device has a
unique MAC (Media Access Control) address. The MAC address is assigned at the factory and
consists of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know
the MAC address of the devices to configure this screen.
To change your NBG6616's MAC filter settings, click Network > Wireless LAN 2.4G/5G > MAC
Filter. The screen appears as shown.
Chapter 11 Wireless LAN
DESCRIPTION
Select this to turn on bandwidth management for the Guest WLAN network.
Enter a number to specify maximum bandwidth the Guest WLAN network can use.
Select Static WEP, WPA-PSK, WPA, WPA2-PSK or WPA2 to add security on this
wireless network. The wireless clients which want to associate to this network must have
same wireless security settings as this device. After you select to use a security, additional
options appears in this screen. See
different security modes. Or you can select No Security to allow any client to associate
this network without authentication.
Note: If the WPS function is enabled (default), only No Security and WPA2-PSK are
available in this field.
Click Apply to save your changes back to the NBG6616.
Click Cancel to reload the previous configuration for this screen.
NBG6616 User's Guide
Section 11.3 on page 91
100
for detailed information on