Make sure the power LED is on (not blinking).
1
Press the WPS button for more than three seconds and release it. Press the WPS button on another
2
WPS-enabled device within range of the NBG6616.
Note: You must activate WPS in the NBG6616 and in another wireless device within two
minutes of each other.
For more information on using WPS, see
1.7 LEDs
Figure 1 Front Panel
The following table describes the LEDs.
Table 1 Front panel LEDs
LED
Power
Chapter 1 Introduction
WAN
LAN 1-4
Power
COLOR
STATUS
DESCRIPTION
Green
On
The NBG6616 is receiving power and functioning properly.
Blinking
The NBG6616 is in the process of starting up or default
restoring.
Off
The NBG6616 is not receiving power.
NBG6616 User's Guide
Section 8.2 on page
USB 1/2
5G WLAN
2.4G WLAN
14
56.
WPS Button
WPS