Restart Screen; Language Screen - ZyXEL Communications NBG6616 User Manual

Table 79 Maintenance > Backup/Restore (continued)
LABEL
Upload
Reset
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default NBG6616
IP address (192.168.1.1). See
your computer's IP address.

25.8 Restart Screen

System restart allows you to reboot the NBG6616 without turning the power off.
Click Maintenance > Restart to open the following screen.
Figure 123 Maintenance > Restart
Click Restart to have the NBG6616 reboot. This does not affect the NBG6616's configuration.

25.9 Language Screen

Use this screen to change the language for the Web Configurator.
Select the language you prefer and click Apply. The Web Configurator language changes after a
while without restarting the NBG6616.
Chapter 25 Maintenance
DESCRIPTION
Click Upload to begin the upload process.
Note: Do not turn off the NBG6616 while configuration file upload is in progress.
After you see a "configuration upload successful" screen, you must then wait one minute
before logging into the NBG6616 again. The NBG6616 automatically restarts in this time
causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Pressing the Reset button in this section clears all user-entered configuration information
and returns the NBG6616 to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
NBG6616. Refer to the chapter about introducing the Web Configurator for more
information on the RESET button.
NBG6616 User's Guide
Appendix B on page 198
178
for details on how to set up